Fire Protection Clothing (Structural / Proximity)
Our multi-layer garments protect against heat, flame and smoke. Typical construction includes an outer shell (aramid/para-aramid), a moisture barrier and a thermal liner. Ergonomic cuts, reinforced seams, reflective tapes, knee/elbow reinforcements and radio pocket placements increase operational safety and comfort.
Selection Guide: Choose by Use Case
Select garments by mission profile, exposure duration and comfort requirements. Typical scenarios and suggestions:
| Scenario | Recommended Set | Standard | Note |
|---|---|---|---|
| Structural firefighting (urban) | Structural turnout gear | EN 469 Level 2 | Higher heat/flame resistance with comfort balance |
| High radiant heat approach | Proximity (aluminised) | EN 1486 | Reflects radiant heat; short approach times |
| Industrial response | Structural + special gloves/hood | EN 469 + EN 659 | Add-ons per chemical/splash risk |
Layer Structure, Comfort & Equipment
Layer combinations vary by brand/model; the table below outlines a typical setup.
| Component | Material / Property | Function |
|---|---|---|
| Outer Shell | Aramid / Para-aramid, flame-retardant | Flame/abrasion resistance, mechanical protection |
| Moisture Barrier | Breathable membrane, liquid-proof | Liquid/splash barrier with breathability |
| Thermal Liner | Felt/aramid blend with comfort lining | Thermal insulation and moisture management |
| Reflective Tape | High-visibility, heat-resistant | Conspicuity in low visibility |
| Seams & Reinforcements | Aramid thread; knee/elbow/shoulder reinf. | Durability and longer service life |
Sizing & Fit Options
Standard sizes range from XS–3XL. Sleeve/leg lengths are available as Short / Regular / Long. Choose via fitting session or detailed size charts.
Standards & Compatible Accessories
Compliance
- EN 469 (Structural firefighting garments) — Level 2 options
- EN 1486 (Proximity — aluminised approach suits)
- EN 659 (Firefighter gloves), EN 443 (Helmet/Hood), EN 15090 (Boots)
Equipment & Add-Ons
- Pockets/loops for radios and gas detectors
- Removable knee/elbow pads
- High-heat resistant zippers and closures
Care, Cleaning & Inspections
Regular cleaning and inspection are essential to maintain protection. General intervals:
| Interval | Action | Description |
|---|---|---|
| After each use | Visual check / airing | Cuts, burns, seam integrity, contamination |
| Routine | Manufacturer-approved washing | No bleach/softener; low heat; fully dry |
| Every 6–12 months | Detailed inspection | Barrier integrity and reflective tape condition |
Frequently Asked Questions
What’s the difference between EN 469 Level 1 and Level 2? ▾
Level 2 requires higher thermal/flame performance and durability; it’s typically chosen for urban structural operations.
When is a proximity suit required? ▾
For short-duration approaches to intense radiant heat (e.g., industrial furnaces, aircraft fire approach), aluminised sets are used.
What should I consider during cleaning? ▾
Avoid bleach and softeners; follow the manufacturer’s detergent/temperature guidance. Dry thoroughly and store away from direct sunlight.